Dell DX6000 Manual de instalación y configuración - Página 14

Navegue en línea o descargue pdf Manual de instalación y configuración para Servidor Dell DX6000. Dell DX6000 43 páginas. Rack installation instructions — static rails
También para Dell DX6000: Manual complementario (4 páginas), Instrucciones de instalación del hardware (2 páginas), Manual del usuario (46 páginas), Manual de instalación y configuración (35 páginas), Manual de introducción (28 páginas), Aviso (28 páginas), Aviso (20 páginas), Visión general (19 páginas), Manual de configuración (9 páginas), Manual de configuración (9 páginas), Nota de publicación (8 páginas), Manual de referencia (12 páginas), Manual de configuración (7 páginas), Nota de publicación (6 páginas), Nota de publicación (5 páginas), Notas de publicación (5 páginas), Instrucciones de instalación (2 páginas), Instrucciones de instalación (2 páginas)

• olderThan(dateSpec) - matches if the header value is a date and that date is older than the date

given, which may be either an absolute date or a relative (to execution time) date.

• intValue(int) – matches if the header value is an integer and executes the specified comparison

against that integer (greater than, less than, equal to, etc).

Typical boolean and grouping operators are also available, so it is possible to easily construct more

sophisticated filters (e.g. (olderThan('365d') and not olderThan('730d')) or matches('^Mon\s.*') to

express "between one and two years old or on Mondays").

3.1.3. Replicator Service

A DX Content Router node's Replicator service serves as a subscriber to one remote cluster's

Publisher service. The Replicator's purpose is to receive UUIDs from the Publisher service, and

then schedule those UUIDs for replication (or deletion) in its local cluster. The Replicator can

be configured to periodically poll, using an HTTP GET request, one or more remote Publishers

to obtain a list of UUIDs to be replicated or deleted. Upon receiving these lists, the Replicator

immediately writes the UUIDs to a queue on its local disk. The Replicator then attempts to process

each write or delete. Once completed the UUID is removed from the queue.

Version 2.2

December 2010