Dell DX6012S Manual de instalación y configuración - Página 12

Navegue en línea o descargue pdf Manual de instalación y configuración para Servidor Dell DX6012S. Dell DX6012S 35 páginas. Rack installation instructions — static rails
También para Dell DX6012S: Manual complementario (4 páginas), Instrucciones de instalación del hardware (2 páginas), Manual del usuario (46 páginas), Manual de instalación y configuración (43 páginas), Manual de introducción (28 páginas), Aviso (28 páginas), Aviso (20 páginas), Visión general (19 páginas), Manual de configuración (9 páginas), Manual de configuración (9 páginas), Nota de publicación (8 páginas), Manual de configuración (7 páginas), Nota de publicación (6 páginas), Nota de publicación (5 páginas), Notas de publicación (5 páginas), Manual de introducción (47 páginas), Instalación (2 páginas), Instalación de bastidores (2 páginas)

to return to the main licensing page. Valid keys will be reflected on the main licensing page after

successful entry.

2.3.3.3. Publishing a License

Entering hardware and capacity keys in the licensing interface will save the keys to the CSN's local

storage. To create a single license file that can be used by the storage cluster, administrators must

publish all the saved changes. The licensing interface denotes any saved but not published keys

with an 'Unpublished' icon in the 1st column to visually assist with determining when a license needs

to be published. To Publish all saved changes, click the blue 'Publish' button at the bottom of the

page. This will create a signed license file with all saved changes and update the license file location

the storage cluster monitors for license updates. Once the license file has been created after the

initial install, the storage nodes can be booted.

Note

DX Storage scans for license updates every 15 minutes so it may be up to that long

before a newly published license is registered in a running storage cluster.

2.3.3.4. Repurposing License Keys

In the event of a cluster reorganization or decommission, an administrator may remove one or more

license keys from one cluster and reuse them in another cluster. To remove a key, simply click the

'Remove' button next to an individual license key. The banner at the top of the page will denote that

there are unpublished changes that need to be saved for the reduced capacity license associated

with the removed key. Once a license key has been removed from the published license for one

cluster it can then be entered into the license interface for a different cluster.

2.4. Booting DX Storage Nodes

Once the CSN has been configured and rebooted and a DX Storage license has been published

with licensed capacity, DX Storage nodes may be powered on on the internal network. DX Storage

nodes require no additional pre-configuration other than to ensure they are configured in BIOS to

network boot. As long as that's the case the nodes will automatically receive an IP address from the

CSN as well as the pre-configured CAStor software and cluster configuration.

Admins may wish to first ensure that the CSN has had adequate time to sync with a reliable NTP

source as a precautionary step prior to booting the nodes. To do this simply type 'ntptrace' at a

system command line. The returned output should contain a stratum value of '15' or lower indicating

Version 2.0

December 2010