Chris King GripNut Manual - Página 2

Navegue en línea o descargue pdf Manual para Accesorios para bicicletas Chris King GripNut. Chris King GripNut 2 páginas.

Imprimir página
vice your headset. In wet conditions, ser-
vice may be necessary as often as every
6 months; in dry conditions, up to every
5 years.
Service of Bearings
• Our sealed bearings have removable
snap rings holding the seals in place.
Carefully remove snap ring and then
seal to gain access to the bearings.
Flush with solvent, blow dry, then lu-
bricate with a waterproof grease and
reassemble. Reuse seals and snap
rings unless damaged.
• If necessary, seals and snap rings are
available through your dealer or di-
rectly from Chris King Precision Com-
ponents.
PLEASE NOTE: Water is the most com-
mon cause of problems with any sealed
bearing. When water enters the frame
through breather or other holes it can
eventually work its way to the head tube
and into the headset bearings. High pres-
sure spray wash, transporting or riding
the bicycle in the rain, or submersion in
water while riding can quickly lead to this
condition. Although the stainless steel
bearings will resist corrosion, the grease
will eventually deteriorate. Avoid these
situations if possible or service as if in
wet conditions.
Removal and
Reinstallation
• Remove cups from head tube with a
standard cup removal tool, taking
care that tool contacts the inside
edges of the cup, not the bearing.
• To remove base plate from fork, we
recommend using a 1/4" or 3/8" drift
punch alternating strikes on either
side of fork crown to lessen the pos-
sibility of warping or bending.
• After removing base plate from fork,
carefully inspect for damage. Some
warpage may flatten upon reinstalla-
tion. If not, or if bearing contact sur-
face has become damaged, replace.
• Base plates and other parts are avail-
able individually through your dealer
or directly from Chris King Precision
Components.
Warranty
Chris King Precision Components war-
rants its bicycle headsets to be free from
defects in materials or workmanship for
a period of 10 years from the original date
of purchase. Any Chris King product that
is found by Chris King Precision Com-
ponents to be defective in materials or
workmanship will be repaired or replaced
at the sole discretion of Chris King Preci-
sion Components providing it is returned
to the factory freight prepaid. This war-
ranty does not cover damage or failure
resulting from misuse, abuse, alteration,
neglect, normal and reasonable wear and
tear, crash or impact, failure to perform
routine maintenance as instructed, or use
other than that for which the product was
intended.
If a defect is found, our entire liability and
your sole remedy shall be, at our option,
free repair or replacement. Chris King
Precision Components shall not be held
liable for any indirect, special, or conse-
quential damages. The warranty does
not cover any Chris King Precision Com-
ponents product where the serial num-
ber has been altered or removed. This
written express warranty is in lieu of all
other warranties, implied or expressed,
and does not cover any representation
or warranty made by dealers beyond the
provisions of this warranty. This warranty
gives you specific legal rights, and you
may also have other rights which vary
state to state.
Lock
ring
Thread
collet
Adjusting
ring
Bearing
cups
Base
plate
Thank you for your purchase!
KING CYCLE GROUP
2801 NW Nela Street
Portland, Oregon 97210
800.523.6008
http://www.chrisking.com
Rev. 3/04-A