Dell EMC PowerEdge C6420 Manual de referencia - Página 18
Navegue en línea o descargue pdf Manual de referencia para Servidor Dell EMC PowerEdge C6420. Dell EMC PowerEdge C6420 26 páginas.
Imprimir página
System Profile Settings
You can use the System Profile Settings screen to enable specific system performance settings such as power management.
Viewing System Profile Settings
To view the System Profile Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click System Profile Settings.
System Profile Settings details
About this task
The System Profile Settings screen details are explained as follows:
Option
Description
System Profile
Sets the system profile. If you set the System Profile option to a mode other than Custom, the BIOS
automatically sets the rest of the options. You can only change the rest of the options if the mode is
set to Custom.This option is set to Performance Per Watt (DAPC) by default. DAPC is Dell Active
Power Controller.Other options include Performance Per Watt (OS), Performance, and Workstation
Performance.
CPU Power
Sets the CPU power management. This option is set to System DBPM (DAPC) by default. DBPM is
Management
Demand-Based Power Management. Other options include OS DBPM, and Maximum Performance.
Memory
Sets the speed of the system memory. You can select Maximum Performance, Maximum Reliability,
Frequency
or a specific speed. This option is set to Maximum Performance by default.
Turbo Boost
Enables or disables the processor to operate in the turbo boost mode. This option is set to Enabled by
default.
C1E
Enables or disables the processor to switch to a minimum performance state when it is idle. This option is
set to Enabled by default.
C States
Enables or disables the processor to operate in all available power states. This option is set to Enabled by
default.
Write Data CRC
Enables or disables the Write Data CRC. This option is set to Disabled by default.
Memory Patrol
Sets the memory patrol scrub frequency. This option is set to Standard by default.
Scrub
Memory Refresh
Sets the memory refresh rate to either 1x or 2x. This option is set to 1x by default.
Rate
Uncore
Enables you to select the Processor Uncore Frequency option.Dynamic mode enables the processor
Frequency
to optimize power resources across cores and uncores during runtime. The optimization of the uncore
frequency to either save power or optimize performance is influenced by the setting of the Energy
Efficiency Policy option.
18
Pre-operating system management applications
NOTE:
All the parameters on the system profile setting screen are available only when the System
Profile option is set to Custom.