DH Lifelabs SAHP-21BL12C Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Limpiador de aire DH Lifelabs SAHP-21BL12C. DH Lifelabs SAHP-21BL12C 9 páginas.

Imprimir página

Connectivity

Sciaire Essential can connect with your smart

device when you download the DH Lifelabs App.

Follow the steps in the App.

DH Lifelabs App

1. Install DH Lifelabs app on a smartphone.

2. Turn on Location Authorization and Bluetooth function for the DH Lifelabs app.

3. Open the DH Lifelabs app.

4. Follow in-app instructions.

Manual set up:

1. Select the device you have.

2. The DH Lifelabs app will read your Wi-Fi network.

3. Follow in-app instructions by turning on the DH Lifelabs device.

4. Long-press the Wi-Fi button for 3 seconds to enable Bluetooth pairing.

5. Connect to the device hotspot "SmartLife-XXXX"

6. Follow any additional in-app steps to complete DH Lifelabs device setup.

To disconnect from the network, press the Wi-Fi Indicator. The unit will beep

and the indicator will flash white and will dim off after 30s.

Cleaning and Maintenance

Always unplug the device while cleaning it. Use a dry cloth to

clean the exterior and do not use any chemicals or cleaners.

Cleaning the Air Quality Sensor

The inlet for the air quality sensor is located at the back of the

machine as shown. The inlet should be cleaned every 2 months

using a vacuum or with a cotton swab that has been lightly

moistened with clean water.

GET IT ON

AIR QUALITY SENSOR

Rep

Filter Replacement

3-in-1 HEPA Filter Replacement

The filter should be replaced every 12 months or when the Filter Replacement Indicator

on the Control Panel is illuminated. This time frame is intended as a guideline. The filter

may need to be replaced earlier or later depending on how often the device is used and

the surrounding environment. In environments with a high concentration of contaminants

such as dust, pet dander, or cigarette/cigar smoke the filter may need to be replaced

more frequently.

NOTE: The HEPA filter is not washable. DO NOT immerse it in water.

Make sure the Purifier is OFF and unplugged.

Remove the bottom cover (see Quick Start Guide, page 5).

Remove the old filter.

Inspect the screen on the air inlet and if necessary clean any excess dust or

dirt from the screen using a hand held vacuum. Clean out any remaining dust or hair

inside the air purifier with a vacuum hose.

Unwrap the new filter and place it into the device. Secure the bottom cover (see

Quick Start Guide, page 5).

Plug in and turn on the air purifier. After replacing the filter, press and hold the Filter

Replacement Indicator for 3 seconds to reset.