Dell PowerEdge 2300 Manual de actualización - Página 21

Navegue en línea o descargue pdf Manual de actualización para Servidor Dell PowerEdge 2300. Dell PowerEdge 2300 24 páginas. Vga card installation instructions
También para Dell PowerEdge 2300: Manual de instalación (2 páginas), Inicio rápido y conexiones (5 páginas), Manual de actualización (23 páginas), Instrucciones de instalación de la estantería (26 páginas), Instrucciones de instalación (1 páginas)

support.dell.com

To install an upgrade microprocessor, perform the following steps:

Insert the new microprocessor into the system board connector (see

Figure 1-8).

Press the microprocessor firmly into its connector until it is fully seated and the

latches snap into place.

You must use up to 25 lb of force to fully seat the microprocessor.

For Pentium III microprocessors, you do not need to change the jumper settings

on the system board.

For Pentium II microprocessors, set the speed jumper to the speed of the

microprocessor.

Upgrade microprocessors have a heat sink with a notch for engaging a threaded

stud on the system board, as shown in Figure 1-8.

Repeat steps 1 and 2 for your second upgrade microprocessor or to install a

terminator card.

install this retention

pin after the cooling

shroud is installed

on PowerEdge 2300

systems only

threaded stud

, ' !

Dell PowerEdge Systems — Microprocessor Upgrade

1-17