Dell PowerEdge systems 6300 Manual de instalación - Página 4

Navegue en línea o descargue pdf Manual de instalación para Servidor Dell PowerEdge systems 6300. Dell PowerEdge systems 6300 8 páginas. Systems 1 x 2 backplane
También para Dell PowerEdge systems 6300: Información sobre la instalación (6 páginas), Manual de instalación (28 páginas), Instalación de bastidores (37 páginas), Manual del usuario (42 páginas), Instalación de bastidores (34 páginas), Manual de instrucciones de instalación (12 páginas), Manual de sustitución (3 páginas), Información sobre la instalación (6 páginas)

Imprimir página
Dell PowerEdge systems 6300 Manual de instalación
2
Dell PowerEdge 63xx Systems—Installing a Microprocessor or Terminator Card
1.
Turn off the system, including any attached peripherals, and disconnect the AC
power cable from its power source.
NOTICE: See "Protecting Against Electrostatic Discharge" in the safety
instructions at the front of your computer's Installation and Trouble-
shooting Guide.
2.
Remove the computer cover.
See "Checking Inside the Computer" in your system's Installation and Trouble-
shooting Guide for more information.
3.
Remove the cooling shroud.
See "Checking Inside the Computer" in your system's Installation and Trouble-
shooting Guide for more information.
4.
Lift the latches on each end of the guide bracket assembly (see Figure 1). Pivot
the retention clips away from the guide bracket assembly, then slide the SEC car-
tridge or terminator card out of the guide bracket assembly.
heat sink
guide-bracket assembly
Figure 1. Removing a Microprocessor or Terminator Card
SEC cartridge
retention clips (2)
latches (2)