Dell PowerEdge systems 6300 Manual de instrucciones de instalación - Página 8

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Servidor Dell PowerEdge systems 6300. Dell PowerEdge systems 6300 12 páginas. Systems 1 x 2 backplane
También para Dell PowerEdge systems 6300: Información sobre la instalación (6 páginas), Manual de instalación (28 páginas), Instalación de bastidores (37 páginas), Manual del usuario (42 páginas), Manual de instalación (8 páginas), Instalación de bastidores (34 páginas), Manual de sustitución (3 páginas), Información sobre la instalación (6 páginas)

SMB Connector and SCSI Cable Strain-Relief Kit Installation Instructions

!"# $

Dell PowerEdge 6300 and 4300 computer systems equipped with a Dell PowerEdge

SDS 100 storage system include two strain-relief clips or one strain-relief bracket in

the cable kit. When installed, the bracket or clips prevent deflection of the SCSI

cables connected to the host adapter card in the system. Deflection of the SCSI inter-

face cables can damage the SCSI host adapter card.

The following items are included in the cable strain-relief kit:

Two long or two short SCSI cables

Two plastic cable strain-relief clips with adhesive backs or one strain-relief bracket

Two alcohol wipes

If your kit includes SCSI strain-relief clips, perform the following steps to install the

clips:

Locate the flat area on the computer's back panel to the right of the redundant

arrays of independent disks (RAID) controller card connectors.

The flat area is located between the chassis ventilation holes and the edge of the

computer cover.

NOTE: Do not affix the cable strain-relief clips over the chassis ventilation holes or

on the edge of the computer cover.

Use the alcohol wipes to thoroughly clean the area on the back panel.

Peel the plastic liner from the back of the cable strain-relief clip to expose the

adhesive tape.

Orient the plastic clip so that the flat tab is on the top and the grooved tab is on

the bottom (see Figure 6).