Dell PowerVault NX1950 Manual de información importante - Página 17

Navegue en línea o descargue pdf Manual de información importante para Servidor Dell PowerVault NX1950. Dell PowerVault NX1950 26 páginas. For vmware esx server software
También para Dell PowerVault NX1950: Manual de implantación (34 páginas), Primeros pasos (49 páginas), Manual de instalación y solución de problemas (48 páginas), Manual de implantación (38 páginas), Manual de actualización (18 páginas), Manual de referencia (4 páginas), Puesta en marcha (2 páginas), Utilizando (2 páginas), Manual de configuración (11 páginas)

9 The Configure or Skip RAID window appears. Perform the following

steps:

Select one of the following options, and then click Continue:

•

Configure RAID

•

Skip RAID configuration

NOTE:

both the internal hard disk drives, and this is the supported

hardware configuration for your system.

If you selected Skip RAID configuration, go to step 10.

If you selected Configure RAID, configure RAID with one of the

following options:

•

Click Go to Advanced Wizard at the top left of the page and

follow the prompts.

•

Select a RAID level and click Continue.

NOTE:

boot disk.

The RAID configuration summary appears.

Click Continue.

The following message appears:

All existing virtual disk(s) on this

controller will be deleted and all data will

be lost.

Click OK to continue.

The Select an Operating System to Install window appears.

10 To set up a new boot partition, select the appropriate file system and

size for your partition and click Continue.

NOTICE:

window appears. Click Continue. Server Assistant deletes all existing

partitions on the hard drive.

NOTE:

NTFS-NT file system.

The Network Adapter(s) configuration window appears.

Your system was pre-configured with hardware RAID1 using

Select RAID1 to ensure adequate redundancy for the

If the hard drive has a partition, the Confirm to delete partition

For maximum system security, Dell recommends selecting

Important Information