Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor Manual del usuario - Página 33

Navegue en línea o descargue pdf Manual del usuario para Monitor Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor. Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor 50 páginas. Flat panel monitor
También para Dell 2407WFP-HC - UltraSharp - 24" LCD Monitor: Manual de instalación (2 páginas), Folleto y especificaciones (3 páginas)

Imprimir página

AC power cord connector

DC power connector for Dell™ Soundbar

DVI connector

VGA connector

Composite video connector

S-Video connector

Component video connectors

USB upstream port

USB downstream ports

To connect your monitor to the computer perform the following steps/instructions.

Turn off your computer and disconnect the power cable.

Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your

computer. Do not use both cables on the same computer. The only case in which both cables can be used is if they are connected to two different

computers with appropriate video systems. (Graphics are for illustration only. System appearance may vary).

Connect the upstream USB port (cable supplied) to an appropriate USB port on your computer .

Connect USB peripherals to the downstream USB ports (rear or side) on the monitor. (See

Plug the power cables for your computer and monitor into a nearby outlet.

Turn on the monitor and computer.

If your monitor displays an image, installation is complete. If it does not display an image, see

Use the cable holder on the monitor stand to neatly organize the cables.

NOTE:

If your computer does not support the DVI connector, you can leave the cable unconnected or remove it.

NOTE:

For USB peripherals already connected to your computer, changing the USB connection to your monitor is not necessary.

Using the Front Panel Buttons

Use the control buttons on the front of the monitor to adjust the characteristics of the image being displayed. As you use these buttons to adjust the controls,

an OSD shows their numeric values as they change.

Input Source Select

Use Input Source Select button to select between five different video signals that may be connected to your monitor.

1. VGA input

2. DVI-D input

3. S- Video input

4. Composite video input

5. Component video

input

As you cycle through the inputs you will see the following messages to indicate currently selected input source. It may take 1 or 2

seconds for the image to appear.

If either VGA or DVI-D input is selected and both VGA and DVI-D cables are not connected, a floating dialog box as shown below appears.

If either S-Video or Composite input is selected and both cables are not connected or the video source is turned off, the screen does not

have an image. If any button is pressed (except power button), the monitor displays the following message:

rear

bottom

view for details.)

Solving Problems.