Dell POWER VAULT 130T LIBRARY 130T Manual de instalación - Página 11

Navegue en línea o descargue pdf Manual de instalación para Almacenamiento Dell POWER VAULT 130T LIBRARY 130T. Dell POWER VAULT 130T LIBRARY 130T 13 páginas. Tape library
También para Dell POWER VAULT 130T LIBRARY 130T: Folleto de seguridad (10 páginas)

Imprimir página

Close the hinged door at the rear of the library.

10. Tighten the two thumbscrews to secure the door.

11. Connect the SCSI cables and/or terminator to the SCSI connectors on the rear of the

tape drive.

How to Set the Drive SCSI ID

If you are replacing an existing drive, you do not have to configure the SCSI ID. The drive

will retain the same ID as the previous drive.

Moving Through the Menu

Move through the menu by observing the choices and the cursor (>) on the display and

pressing the following function buttons on the operator panel:

•

The up and down arrow buttons move the cursor up and down and cause the display

list to scroll if the list is more than four items long.

•

The ENTER button selects the menu or action indicated by the cursor.

•

The MENU button causes the previous (higher) menu to display.

•

If you are adding a new drive, you must configure the new drive count and SCSI ID in

the library configuration.

Configure the Drive from the Operator Panel

To complete the configuration after installing the new drive or an additional drive do the

following steps:

Move the cursor to the item you wish to configure and press ENTER. The operator

panel displays detailed prompts to assist you.

Set Drive Count: Enter the new number of tape drives installed in the library.

(Setting this first ensures that the library prompts you to set the SCSI IDs for all the

drives present. If changed, the system prompts for reset before exiting Set

Configuration.

Reset the library to enable drive communication to the new drive. If you set the SCSI

ID for a drive added without doing a reset, you will get a message "drive not

communicating or missing" .

Press MENU to display the Main menu.

On the Main menu, move the cursor to Library Utilities and press ENTER to display

the Library Utilities menu.

On the Library Utilities menu, move the cursor to Set Configuration and press ENTER

to display the Set Configuration menu.

Set Drive SCSI ID: Set the SCSI ID for each tape drive.

Drive Tray Conversion Instructions