Dell PowerEdge 4400 Manual de instalación - Página 12

Navegue en línea o descargue pdf Manual de instalación para Almacenamiento Dell PowerEdge 4400. Dell PowerEdge 4400 20 páginas. Wake-on-lan (wol) support on dell servers
También para Dell PowerEdge 4400: Manual de instalación (42 páginas), Manual de instalación (28 páginas), Instalación de bastidores (37 páginas), Manual de actualización (8 páginas), Información actualizada (8 páginas), Manual del usuario (42 páginas), Instalación de bastidores (34 páginas), Manual de instalación del hardware (40 páginas), Manual de instalación (36 páginas), Manual (15 páginas)

Imprimir página
Dell PowerEdge 4400 Manual de instalación
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
1-8
Microprocessor Upgrade Installation Guide
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
3.
Run the Dell Diagnostics to verify that the new microprocessor is operating
correctly.
See your User's Guide and your Installation and Troubleshooting Guide for additional
information on running the Dell Diagnostics and troubleshooting any problems that
may occur.
,QVWDOOLQJ DQ 8SJUDGH 0LFURSURFHVVRU LQ
3RZHU(GJH 6\VWHPV
This section provides instructions for:
‡
Removing the SEC cartridge and heat sink
‡
Installing the new SEC cartridge and heat sink
5HPRYLQJ WKH 6(& &DUWULGJH DQG +HDW 6LQN
1.
Turn off the system, including any attached peripherals, and disconnect the power
cable from the electrical outlet.
2.
Open the system cover.
See your system Installation and Troubleshooting Guide for specific instructions,
if needed.
3.
Remove the air blower, if present (see Figure 1-4).
a.
Unplug the Y -shaped air blower power cable from the interposer board.
b.
Position your right thumb on the outside of the power supply enclosure
beside the narrower front part of the air blower.
c.
Push firmly on the power supply enclosure to move it slightly away from the
air blower and allow extra clearance to remove the air blower.
d.
With your left hand, pull the front of the air blower upward and away from
the power supplies to unseat it. You should hear it unsnap.
By pulling the air blower slightly away from the power supplies, you avoid the
need to use excessive force to clear the power supply enclosure.
e.
Slide the air blower slightly up and toward the front of the chassis until the
metal tab at the back right of the air blower slides out of the small slot at the
top back of the chassis.
DELL CONFIDENTIAL - Preliminary
9/11/00