Dell PowerVault 725N Actualización del firmware - Página 7
Navegue en línea o descargue pdf Actualización del firmware para Almacenamiento Dell PowerVault 725N. Dell PowerVault 725N 12 páginas. Nas systems with software raid
También para Dell PowerVault 725N: Manual de actualización (10 páginas), Información actualizada (28 páginas)
Imprimir página
Enable the Dell OpenManage™ Kick-Start utility and manually create your DHCP
12
settings:
If it is not on, turn on the NAS system.
a
The NAS system must be turned on to set the IP address using the Kick-Start
utility.
Click the Start button and point to Programs→ Dell Reinstallation Console→
b
Dell OpenManage Kick-Start.
When asked if you want to run the program, click Yes.
c
At the bottom of the Dell OpenManage Kick-Start window, click Setup.
d
Click Add.
e
In the Add Scope window, enter the following information, and then click OK.
f
•
Starting IP Address: 10.40.10.10
•
Ending IP Address: 10.40.10.20
Subnet Mask: 255.255.255.0
•
•
Gateway IP Address: 10.40.10.1
Click OK to close the Add Scope window.
g
Click Interfaces for DHCP Server so that it is checked.
h
Click OK to close the Setup window.
i
Click Enabled at the bottom of the Dell OpenManage Kick-Start window to start
j
the integrated DHCP server.
®
Start the Intel
PXE server and verify that the services are running:
13
Click the Start button and point to Programs→ Dell Reinstallation Console→
a
Intel PXE Server.
In the PXE Configuration Utility window, right-click the server name,
b
PV725REC, and then select Start/Stop Services.
Verify that the proxy DHCP/Boot PXE and M/TFTP services are installed and
c
running correctly by selecting Stop and then selecting Start.
If the services are running, the indicator displays Running after you click Start
and displays Stopped after you click Stop.
Click OK.
d
Reboot your NAS system by pressing the power button.
14
Upgr ading Yo ur 39160 SC SI Card Fir mware
1-5