Dell PowerVault MD3000i Manual de sustitución

Navegue en línea o descargue pdf Manual de sustitución para Almacenamiento Dell PowerVault MD3000i. Dell PowerVault MD3000i 4 páginas. Configuration for vmware esx server software
También para Dell PowerVault MD3000i: Manual de sintonización (32 páginas), Nota de apoyo (22 páginas), Manual de actualización (28 páginas), Manual del usuario (46 páginas), Manual de configuración (10 páginas)

WARNING:

A WARNING indicates a potential for property damage, personal injury,

or death.

Replacing a RAID Controller Module

in a Single-Controller MD3000i

This document describes how to replace a failed RAID controller module in a

single-controller MD3000i. After replacing the RAID controller, you will also

need to update its controller and NVSRAM firmware. These steps are described

in "Updating RAID Controller and NVSRAM Firmware on the Replacement

RAID Controller Module" later in this document.

Replacing the RAID Controller Module

WARNING:

Always wear a wrist grounding strap when handling equipment with

static-sensitive components. See your

information.

Removing the RAID Controller Module

1 Power down the MD3000i enclosure.

2 Disconnect all cables from the failed RAID controller module.

3 Push up on the release tab on the left side of the module (see Figure 1).

4 At the same time, pull out on the release lever. When the lever is pulled out,

the controller module partially ejects from the enclosure.

5 Remove the module from the enclosure and place it on a flat, secure surface.

CAUTION:

To avoid damage to the sensitive EMI (ElectroMagnetic Interference)

contacts on the bottom of the controller module, do not stack or place the module on a

hard surface.

Product Information Guide

for safety