Dell PowerVault MD3200i Series Manual de implantación - Página 6

Navegue en línea o descargue pdf Manual de implantación para Almacenamiento Dell PowerVault MD3200i Series. Dell PowerVault MD3200i Series 41 páginas. Storage arrays
También para Dell PowerVault MD3200i Series: Manual de actualización (32 páginas), Instrucciones de instalación de la estantería (2 páginas), Manual del usuario (46 páginas), Matriz de apoyo (12 páginas), Manual de instalación (18 páginas), Información actualizada (1 páginas), Matriz de apoyo (11 páginas), Matriz de apoyo (17 páginas), Manual técnico (38 páginas), Libro Blanco (22 páginas), Manual (16 páginas)

Dell PowerVault MD32xxi Configuration Guide for VMware ESX4.1 Server Software

MPIO – With ESX4.1 and vSphere4, customers can benefit from Multi-Path I/O from the ESX4.1 server and

the SAN. This allows for multiple connections to be concurrently used to allow for greater bandwidth.

This is especially important for the PowerVault SAN as each PowerVault member has multiple connections

and now ESX4.1 can take full advantage of these connections.

Third Party MPIO Support – With ESX4.1 and vSphere4, VMware has provided an architecture that

enables storage vendors to provide new and advanced intelligent integration.

Supported Hardware and Software

Refer to the following VMware website for a complete up-to-date list of the prerequisites for installing

VMware ESX server.

http://www.vmware.com/pdf/vsphere4/r40_u1/vsp_40_u1_esx_get_start.pdf

ESX4.1 is the only supported VMware OS for MD32xxi.

As a best practice, Dell recommends using a separate Gigabit Ethernet network switch to handle iSCSI storage

traffic. Each server is connected to two switches. Each switch has a path to the MD32XXi via two dual-port

controllers. In this base HA configuration, the servers, switches, and MD32XXi ports share the same subnet. The

NIC ports serving iSCSI traffic on the ESX servers are teamed in order to re-route traffic in the event of an adapter

failure.

Considerations When Using iSCSI Software or Hardware Initiators for ESX4.1

on the MD32xxi Storage Array

Taking advantage of all of these new features requires some new steps to be taken by ESX administrators.

Configuration is done via either GUI or CLI inside the ESX4.1 server. The remainder of this whitepaper

focuses on installation and configuration of an iSCSI software initiator connection to a PowerVault Series

SAN. Each of these commands can be found inside the

names and IP Addresses are used, they will be different for each environment. This serves as an example

and demonstration of how to configure a new vSphere4 ESX4.1 server correctly and connect it to the

PowerVault SAN.

The following assumptions are made for this example:

1. Running ESX4.1

2. Running latest Dell PowerVault MD32xxi firmware

SCSI SAN C

WARE I

ONFIGURATION

Guide and where

Page 4