Dell PS4100 Manual de mantenimiento del hardware - Página 30

Navegue en línea o descargue pdf Manual de mantenimiento del hardware para Almacenamiento Dell PS4100. Dell PS4100 47 páginas. Storage array
También para Dell PS4100: Manual de hardware (50 páginas), Visión general (7 páginas), Manual de instalación y configuración (41 páginas), Puesta en marcha (2 páginas)

PS4100 Hardware Maintenance Guide

2. Push down on the orange release tab and swing the black lever out.

3. Slide the control module into the chassis until you feel resistance.

4. Rotate the black lever inward, which pushes the control module completely into the slot. The latch on

the lever will snap into place.

5. Reconnect the network cables.

6. If the array was shut down, turn on power to the array.

7. Make sure the control module is operational. See

When connected, the control module cache-to-flash module receives full charge. If it cannot be charged,

its status is reported as BAD in the Group Manager GUI. You must remove the control module and

replace it with another one.

If two control modules are installed but only one is shown in the GUI or CLI, the control module may

not be properly installed. Reinstall the control module. If both control modules still are not shown in the

GUI or CLI, they may not be running the same firmware. Contact your array support provider.

Replacing the MicroSD Card

Each control module includes a microSD card that contains the PS Series firmware.

If a control module fails, remove the microSD card from the failed control module and install the card in the

replacement control module. This will make sure that the new control module is running the same firmware

as the other control module in the array.

You can remove a control module without shutting down the array if the remaining control module has at

least one connected and functioning network interface. If you remove the active control module (the LED

labeled ACT will be green), there will be a short interruption as failover to the secondary control module

occurs.

When you remove the control module, place it on a surface that is protected from electrostatic discharge.

Figure 18 Installing a Control Module

Interpreting Control Module LEDs on page

Maintaining Control Modules

18.