Dell Force 10 Manual - Página 8

Navegue en línea o descargue pdf Manual para Interruptor Dell Force 10. Dell Force 10 29 páginas. Implementing fcoe in the linux operating system

Implementing FCoE in the Linux Operating System

2. Enable the FCoE feature on the Dell Force10 MXL 10/40GbE edge switch by running the

following commands from the Global Configuration Mode of the edge switch command line:

service-class dynamic dot1p

cam-acl l2acl 4 ipv4acl 2 ipv6acl 0 ipv4qos 2 l2qos 1 l2pt 0 ipmacacl 0 vman-qos 0 ecfmacl 0

fcoeacl 2 iscsioptacl 2

feature fip-snooping

fip-snooping enable

protocol lldp

no advertise dcbx-tlv ets-reco

advertise management-tlv system-description system-name

3. Program the server facing ports (internal ports connected to the PowerEdge blade servers) on

the edge switch by running the following commands from the switch command line:

interface TenGigabitEthernet 0/30

no ip address

mtu 12000

portmode hybrid

switchport

spanning-tree pvst edge-port

protocol lldp

dcbx port-role auto-downstream

no shutdown

4. Program the switch facing ports (physically accessible ports on the back of the M1000e chassis)

on the edge switch by running the following commands from the switch command line:

interface TenGigabitEthernet 0/49

description LAG port to Cisco 5020

no ip address

mtu 12000

port-channel-protocol LACP

port-channel 2 mode active

protocol lldp

no advertise dcbx-tlv ets-reco

dcbx port-role auto-upstream

no shutdown

***NOTE: If not in a LAG, omit the highlighted in red above***

5. Create the default VLAN by giving the default-vlan XX command (where XX equals the

VLAN number) from the edge switch command line as seen below:

default-vlan 46

6. Create the FCoE VLAN (this is the actual VLAN that allows FCoE traffic on the edge switch) from

the edge switch command line as seen below:

int vlan 255