Dell Force10 S4810 Manual de configuración - Página 10
Navegue en línea o descargue pdf Manual de configuración para Interruptor Dell Force10 S4810. Dell Force10 S4810 17 páginas. Dell force10 s4810 switch
También para Dell Force10 S4810: Manual de inicio rápido (27 páginas), Manual de implantación (36 páginas), Manual de configuración (17 páginas)
Imprimir página
3
Configure Data Center Bridging (DCB) (Optional)
To enable DCB mode on the switch, use the following commands.
Note: You must complete the Dell recommended switch configuration steps in Sections 2.1 to 2.12
before configuring the switch for DCB mode.
3.1
Disable 802.3x flowcontrol on SFP+ ports
FTOS#configure
FTOS(conf)#interface range tengigabitethernet 0/0 - 47
FTOS(conf-if-range-te-0/0-47)#no flowcontrol rx on tx off
FTOS(conf-if-range-te-0/0-47)#exit
3.2
Disable 802.3x flowcontrol on QSFP ports
FTOS(conf)# interface range fortyGigE 0/48 , fortyGigE 0/52
FTOS(conf-if-range-fo-0/48-52)#no flowcontrol rx on tx off
FTOS(conf-if-range-fo-0/48-52)#exit
3.3
Enable DCB and reload
FTOS(conf)#dcb enable
FTOS(conf)#exit
FTOS#copy running-config startup-config
FTOS#reload
Note: The switch will reboot.
3.4
Create tagged VLAN for all ports and port-channels
FTOS#configure
FTOS(conf)#interface vlan vlan-id
Note: You must supply a VLAN id. The valid range is 2-4093.
FTOS (conf-if-vl-vlan-id*)#no shutdown
FTOS (conf-if-vl-vlan-id*)#tagged tengigabitethernet 0/0-47
FTOS (conf-if-vl-vlan-id*)#tagged port-channel 1
FTOS (conf-if-vl-vlan-id*)#exit
10
SCG1000 | Dell Networking S4810 and Force10 S4810 Configuration Guide for EqualLogic SANs