Dell N1108P-ON Manual de introducción - Página 17

Navegue en línea o descargue pdf Manual de introducción para Interruptor Dell N1108P-ON. Dell N1108P-ON 27 páginas.

Performing the N1100-ON Series Initial

Configuration

The initial configuration procedure is based on the following assumptions:

•

The Dell Networking switch was never configured before.

•

The Dell Networking switch booted successfully.

•

The console connection was established, and the Dell Easy Setup Wizard

prompt appears on the screen of a PC running terminal emulation

software.

The initial switch configuration is performed through the console port. After

the initial configuration, you can manage the switch from the already-

connected console port or remotely through an interface defined during the

initial configuration.

NOTE:

The switch is not configured with a default user name, password, or IP

address.

Before setting up the initial configuration of the switch, obtain the following

information from your network administrator:

•

The IP address to be assigned to the management interface.

•

The IP subnet mask for the network.

•

The IP address of the management interface default gateway.

These settings are necessary to allow the remote management of the switch

through Telnet (Telnet client) or HTTP (Web browser).

On the N1100-ON Series switches, you can use any of the switch ports on the

front panel for in-band management. By default, all in-band ports are

members of VLAN 1.

The Dell Easy Setup Wizard includes prompts to configure network

information for the VLAN 1 interface on the N1100-ON Series switches. You

can assign a static IP address and subnet mask or enable DHCP and allow a

network DHCP server to assign the information.

Refer to the CLI Reference Guide for commands to configure network

information.

Getting Started Guide