Dell PowerConnect 5500 Series Manual de configuración rápida - Página 9

Navegue en línea o descargue pdf Manual de configuración rápida para Interruptor Dell PowerConnect 5500 Series. Dell PowerConnect 5500 Series 17 páginas. Networking mobility starter kit

Imprimir página

Dell Networking Mobility Starter Kit – Quick Setup Guide

13. Enter the default gateway and press enter. The following message is displayed (example):

This is the configuration information that has been collected:

SNMP Interface = "Dell Network Manager"@192.168.2.10

User Account setup = admin

Password = **********

Management IP address = 192.168.2.100

255.255.255.0

Default Gateway = 192.168.2.1

If the information is correct, please select (Y) to save the

configuration and copy to the start-up configuration file. If the

information is incorrect, select (N) to discard configuration and

restart the wizard: [Y/N]

14. Verify that the information is correct and select [Y] to save the configuration.

15. Continue managing the switch either through the console or Telnet, using the CLI or the web

GUI.

Next steps and recommendations

Before connecting the Instant Access Points to the 5500 Series PoE switch, ensure that a DHCP Server is

available and enabled on your network. Connect your DHCP Server to one of the ports on the

PowerConnect 5500 Series PoE switch. In some cases, the DHCP Server will be a function of your

internet provider. For the Dell Networking Mobility Starter Kit example, we are using the DHCP Server

from our internet router. Ensure that the DHCP service is disabled on the PowerConnect 5500 Series

PoE switch if you have another DHCP server on your network.

Getting Started with Dell PowerConnect W-Instant Access Points

The following information will assist you to quickly connect and configure Dell PowerConnect W-Series

Instant Access Point (IAP). After following the simple steps in this section, you'll have a basic wireless

network that will let users access any resource on the subnet used in this Getting Started Guide.

For physical installation information and an overview of the W-105IAP hardware, see the Installation

Guide that's included with the IAP.

For detailed configuration information, see the Dell PowerConnect W-Series Instant Access Point User

Guide.

Connecting your W-IAP105 Instant Access Points

After setting up your PowerConnect 5500 Series PoE switch, you are ready to connect the IAPs.

1. Using standard Cat5 Ethernet cable, connect the ENET port of the W-105IAP to the 5500 Series

PoE switch. All IAPs may be connected at this time, or just a single IAP.

2. The IAPs will boot, obtaining an IP address from the DHCP server you setup in the previous

section. All LEDs will be lit when the boot process completes.

NOTE: While in the provisioning state, access to the network is open to anyone that can connect to

the provisioning SSID. Ensure you complete the steps below in a prompt manner to secure the network.