3 Day Blinds VINYL BLINDS Primeros pasos - Página 3

Navegue en línea o descargue pdf Primeros pasos para Persianas 3 Day Blinds VINYL BLINDS. 3 Day Blinds VINYL BLINDS 10 páginas.

Imprimir página

TO INSTALL CENTER SUPPORT BRACKETS:

• If your hardware packet includes one center support

bracket, position it as close to the top center of the window

casing as possible. If more than one center support bracket

has been provided, position them equidistant from the end

brackets and each other.

WARNING: Do not locate the center support brackets over

any of the moving parts in the headrail.

Proceed to "Valance Blind Installation".

| Vinyl Blinds

• Align the back of the center

support bracket(s) with the

back end of the mounting

brackets. The alignment

is crucial for proper blind

installation.

• Mark the window casing

through the holes in the

top of the center support

bracket. For maximum

stability, the marks should be

made diagonally.

• Using a drill with a

" drill

bit or an awl, make a small

pilot hole at each mark.

• Mount each of the bracket(s)

using two of the screws

provided.

OUTSIDE MOUNT

• Unwrap the cellophane from around the blind stack.

Caution: DO NOT cut the cellophane as the cords or ladders

supporting the blind may be inadvertently cut.

• Lower the blind to its full length. (See "Blind Operation".)

• Draw the blind completely up and set it aside.

• Hold the blind up to the

desired mounting position.

• Once the blind is level,

mark the wall at the lower

corners of each end of the

headrail using a pencil

• Using a flathead

screwdriver, open the

latches of the end

brackets.

• Facing the window,

position the end bracket

marked "LH" above the

top left corner of the

window,

" TO THE LEFT

of the pencil marks.

• Using a pencil, mark the

wall through the holes

in the back of the end

bracket. For maximum

stability, the pencil

marks should be made

diagonally.

• Using a drill with a

" drill

bit or an awl, make a small

pilot hole at each pencil

mark.

• Mount the bracket using

the 2 screws provided.

• Repeat this procedurre for

the right end bracket.