Dell PowerConnect W-650 Manual complementario - Página 41
Navegue en línea o descargue pdf Manual complementario para Interruptor Dell PowerConnect W-650. Dell PowerConnect W-650 42 páginas. Dell networking w-600 controller series
También para Dell PowerConnect W-650: Manual de instalación (20 páginas), Especificaciones (2 páginas)
Imprimir página
The Aruba 620 and 650 Mobility Controllers meet FIPS 140-2 Level 2 requirements. The sections below
describe how to place and keep the switch in FIPS-approved mode of operation. The Crypto Officer (CO)
must ensure that the switch is kept in a FIPS-approved mode of operation.
The switch can operate in two modes: the FIPS-approved mode, and the standard non-FIPS mode. By
default, the switch operates in non-FIPS mode.
Setting Up Your Controller
To set up your controller:
1. Make sure that the controller is not connected to any device on your network.
2. Boot up the controller.
3. Connect your PC or workstation to a line port on the controller.
For further details, see the ArubaOS 6.1 Quick Start Guide.
Enabling FIPS Mode
For FIPS compliance, users cannot be allowed to access the switch until the CO changes the mode of
operation to FIPS mode. There are two ways to enable FIPS mode:
Use the WebUI
Use the Setup Wizard
Enabling FIPS with the Setup Wizard
The Setup Wizard allows you to configure access to the controller, install software licenses, and configure
wireless local area networks (WLANs) for internal or guest users.
The Setup Wizard is available the first time you connect to and log into the controller or whenever the
controller is reset to its factory default configuration. After you complete the Setup Wizard, the controller
reboots using the new configuration information you entered.
For details on running the Setup Wizard, see the ArubaOS 6.1 Quick Start Guide.
Enabling FIPS with the WebUI
The default IP address of the controller is 172.16.0.254. When you connect a PC or workstation to a line port
on the controller, you can connect to this IP address through a Web browser. The system must be
configured to either obtain its IP address via DHCP or have a static IP address on the 172.16.0.0/24
subnetwork.
To log in with the WebUI:
1. Open a Web browser and connect to http://172.16.0.254.
2. Log in.
3. Go to the Configuration > Network > Controller > System Settings page (the default page when
you click the Configuration tab).
Aruba 620, 650 and Dell W-620, W-650 | FIPS 140-2 Level 2 Release Supplement
Chapter 5
Setup and Configuration
Setup and Configuration |
39