Christie 104-001001 Manual de instrucciones de sustitución
Navegue en línea o descargue pdf Manual de instrucciones de sustitución para Proyector Christie 104-001001. Christie 104-001001 8 páginas.
Imprimir página
Lamp and Filter Replacement Instructions
Introduction
Use the following instructions when replacing the lamp or filters in any of the projectors
listed in Table 1, below. The lamp is located at the rear of the projector (below the input
panel) and can be accessed by opening the lamp door. Use only a Christie approved Lamp
and Filter Kit for your specific projector model.
Table 1. Projector Models
Projector Model
Roadster S
+
12K
Roadster S
+
16K
Mirage S
+
14K
Roadster S
+
20K
Warnings
Lamp replacement MUST be performed by a qualified service technician.
Cool the lamp completely and handle by the housing only.
Install the correct wattage lamp supplied by Christie (Refer to Table 1. Projector
Models) and read the Lamp Replacement Procedure in its entirety before proceeding.
Do not touch the glass surface of the lamp. Fingerprints left on the surface can lead
to an intense accumulation of heat known as a "hotspot", which could potentially
result in the lamp shattering. It is recommended to wear clean, lint-free gloves and a
face shield when working with the lamp.
013-100049-03 (Rev.1)
Model Number
Lamp Type (Watts)
38-DSP210-01
38-DSP210-02
38-DSP210-52
38-DSP214-01
38-DSP214-03
38-DSP214-53
38-DSP214-04
38-DSP214-54
104-001001
104-001101-01
1 of 8 Pages
Lamp/Filter Kit Required
03-900519-01P
1.9kW
03-900519-01P
03-900519-51P
03-900518-01P
2.4kW
03-900518-01P
03-900518-51P
03-900518-01P
2.4kW
03-900518-51P
003-000306
3.0kW
003-000306-02