Dell PowerEdge M820 Systems Manual del usuario - Página 19

Navegue en línea o descargue pdf Manual del usuario para Interruptor Dell PowerEdge M820 Systems. Dell PowerEdge M820 Systems 26 páginas. Dell poweredge blade servers getting started guide
También para Dell PowerEdge M820 Systems: Información actualizada (38 páginas), Notas de publicación (27 páginas), Manual del usuario (23 páginas), Manual de información importante (35 páginas), Manual de actualización (32 páginas), Manual de actualización (28 páginas), Manual del usuario (22 páginas), Manual de introducción (12 páginas), Manual del usuario (3 páginas), Manual técnico (46 páginas), Manual de cartera (27 páginas), Manual de introducción (14 páginas), Manual de introducción (12 páginas), Manual técnico (47 páginas)

Dell 10Gb Ethernet Pass Through II

Operating Procedures

4.1

The 10GbE PTM consists of three PhyX® devices and a micro-controller (CPU). This procedure

describes how to update both CPU SW & PhyX® FW using a single .pfw binary file.

The 10GbE PTM is delivered with the latest firmware available at the time of production. New fir-

mare versions will be posted on the Dell support page. The latest firmware can be found at:

http://support.dell.com/support/

Step 1. Download the 10GbE PTM firmware .zip file and extract the .pfw binary file.

Step 2. Connect to the 10GbE PTM using an SSH Client as described in

the 10GbE PTM CLI," on page

Step 3. From the CMC command line, connect to the 10GbE PTM CLI. Enter:

Note:

At least 20 seconds must have passed since the last power cycle of the 10GbE PTM

module before running the following connect command.

$ connect switch-<n>

where <n> is the number of the switch -- 2 in our example.

The prompt should change to #.

Step 4. To start the upgrade process, run the command:

# copy image from-file

The system will now wait for a ".pfw" file to be transferred from the SSH client.

Step 5. In your SSH client, initiate file transfer by pulling down the Transfers menu and clicking

Send Files. Provide the path to the ".pfw" file and send it.

Rev 1.00

Section 2, "Connecting to