Dell S4048-ON Manual de configuración - Página 8

Navegue en línea o descargue pdf Manual de configuración para Interruptor Dell S4048-ON. Dell S4048-ON 30 páginas. Enterprise switches
También para Dell S4048-ON: Manual de configuración (19 páginas), Manual de solución de problemas (29 páginas)

Imprimir página

Switch configuration (OS 9.x)

This section provides steps to configure Dell EMC Networking S4048-ON switches running Dell Networking

OS 9.x (firmware 9.x). If your switches are running firmware Dell Networking OS 10.x (firmware 10.x), follow

the steps in section 3 instead.

Table 2 provides an overview of the switch configuration.

Switch vendor

Switch model

Switch firmware

Note: For proper functionality, the switch must be at the switch firmware version shown in Table 2 before

proceeding with this configuration. Using firmware other than the versions specified in this document may

have unpredictable results.

Note: Firmware downloads and documentation can be found at Dell.com/support.

2.1

Dell EMC recommended switch configuration

The steps in this section show how to configure two S4048-ON switches with a Link Aggregation Group

(LAG). The switches are interconnected using two of the 40GbE Quad Small Form-factor Pluggable (QSFP)

uplink ports, and the LAG is configured for Dynamic Link Aggregation Control Protocol (LACP).

2.1.1

Hardware configuration

1. Power on the two switches.

2. Connect a serial cable to the serial port of the first switch.

3. Using PuTTY or another terminal utility, open a serial connection session to the switch.

4. Open the terminal emulator and configure it to use the serial port (usually COM1 but this may vary

depending on your system). Configure serial communications for 115200,N,8,1 and no flow control.

5. Connect the (QSFP) LAG cables between the switches by connecting port 49 on switch 1 to port 49

on switch 2 and port 50 on switch 1 to port 50 on switch 2. See this configuration in Figure 1.

Dell EMC Networking S4048-ON Switch Configuration Guide for Dell PS Series SANs | SCG1026

Switch specifications (OS 9.x)

Dell EMC Networking S4048-ON

Dell EMC

S4048-ON

9.x (9.10.0.0 or above)