Dell S4100-ON Series Manual de instalación - Página 39
Navegue en línea o descargue pdf Manual de instalación para Interruptor Dell S4100-ON Series. Dell S4100-ON Series 48 páginas.
También para Dell S4100-ON Series: Manual de instalación (47 páginas), Manual de instalación (21 páginas), Manual de instalación (49 páginas)
Imprimir página
NOTE:
Before starting this procedure, be sure that you have a terminal emulation program already installed on your PC. Install
the appropriate drivers to support the USB-B port. For assistance, contact
To access the USB-B console port, follow these steps.
1
Power on the PC.
2
Connect the USB-A end of cable into an available USB port on the PC.
3
Connect the USB-B end of cable into the USB-B console port on the S4100-ON Series switch.
4
Power on the S4100-ON Series switch.
5
Install the necessary USB device drivers. (To download the drivers, go to www.dell.com/support.)
For assistance, contact Dell EMC Technical Support.
6
Open your terminal software emulation program to access the S4100-ON Series switch.
7
Confirm that the terminal settings on your terminal software emulation program are as follows:
•
115200 baud rate
•
No parity
•
8 data bits
•
1 stop bit
•
No flow control
Before you install an OS
After powering on the S4100–ON Series (S4128F-ON, S4148F-ON, and S4148FE-ON) switch, it goes through a power-on self-test
(POST).
POST runs every time the switch is initialized and checks the hardware components to determine if the switch is fully operational before
booting. After POST, the switch uses the Grub bootloader.
To select an entry, use the up and down arrow keys. Press Enter to select an operating software (OS) or enter e to edit the commands
before booting. Enter c for a command line. The selected entry runs automatically in the operating system.
Grub bootloader example
GNU GRUB
version 2.02~beta2+e4a1fe391
+--------------------------------------------------+
|*ONIE: Install OS
| ONIE: Rescue
| ONIE: Uninstall OS
| ONIE: Update ONIE
| ONIE: Embed ONIE
| EDA-DIAG
|
|
|
|
|
|
+--------------------------------------------------+
Your switch comes with ONIE installed.
NOTE:
To access ONIE, use the RJ-45 console port.
ONIE example
ONIE: Install OS
For downloading and installing an OS from a URL
www.dell.com/support
|
|
|
|
|
|
|
|
|
|
|
|
to download the drivers.
Management ports
39