Dell Z9000 Manual - Página 18

Navegue en línea o descargue pdf Manual para Interruptor Dell Z9000. Dell Z9000 48 páginas. Z9000 system
También para Dell Z9000: Manual de inicio rápido (27 páginas)

Imprimir página

NOTE: Dell Networking OS recommends using one person to hold the Z9000 chassis in place while

another person attaches the brackets to the posts.

Attach the bracket "ears" to the rack or cabinet posts using the two screws for each bracket. Ensure

the screws are tightened firmly. The following figure shows the mounting on the I/O side, but you

can use either side.

Installing the Rear Mounting Brackets

To install the rear mounting brackets to the system, follow these steps:

Attach a long extension bracket to the side of the back of the switch using five screws (both sides).

NOTE: Ensure that the bracket bend is facing inwards.

Secure the short L-bracket extension to the rack using four screws (both sides).

NOTE: The screws are not included.

Align and secure the short L-bracket extension to the long extension bracket using four screws.

NOTE: Ensure that the short bracket is attached to the outside of the long bracket.

Attaching the Ground Cable

To attach the ground cable to the chassis, use a single M4x0.7 screw.

The cable itself is not included with the Z9000. To properly ground the chassis, Dell Networking OS

recommends using a 6AWG one-hole lug, #10 hole size, 63" spacing (not included in shipping). The one-

hole lug must be a UL recognized, crimp-type lug.

Install the Z9000