EarthPulse v.5 Pro Manual - Página 4

Navegue en línea o descargue pdf Manual para Gimnasios EarthPulse v.5 Pro. EarthPulse v.5 Pro 12 páginas.
También para EarthPulse v.5 Pro: Manual de inicio rápido (7 páginas)

Imprimir página

GENERAL INSTRUCTIONS TO SET UP EARTHPULSE

(NOTE -- Specific Settings pertaining to different Modes are given beneath in sections pertaining

to each Mode)

Step 1 – Plug Power-Supply Cable into the large jack at back of Program Controller.

Step 2 – Plug Power Supply Adaptor into the electricity outlet on the wall (100-240 volts AC). Use

International Pin Adaptor if required.

Step 3 -- Plug the 2 Coil Sets into the remaining 2 jacks at the back of the Program-Controller.

Step 4 -- Press "On/Off" button on the Program-Controller. The display shows "Sleep On

Command" and instantly boots to "Recover" Mode.

Note: Your system is now ready to use and you need to select and set up the Mode, Timer and

Amplitude.

Step 5 – For arriving at the desired Mode, Press "Up" / "Down" Arrow key.

Step 6 – Once you are at the desired Mode, Press "Select/Start" key. The display now shows the

Mode and the timer set to 8.00 Hours.

Note: You now need to set the Time Duration and the Amplitude.

Step 7 –Press "Up" or "Down" Arrow to set the time duration for which you wish to use

EarthPulse

. Time can be set from 15 minutes to 12 hours with changes in multiples of 15

minutes.

Step 8 – Press "Select/Start" button. EarthPulse

begins to function. This is established by the

blinking of the * in the display and the blue LED light on the Program Controller.

Note: The display now shows the Mode selected and the duration for which the timer is set.

At the end of this time duration, the device will automatically shut down.

Step 9 – Amplitude: The display also shows the Amplitude which has, by default, been set at

70% for all Modes, since it is best suited to a normal user. You can change the amplitude if you

wish. Press "Up" or "Down" Arrow to change the Amplitude between the programmed range of

10% to 100%. Once you arrive at the Amplitude % of your choice, it automatically gets set.

EarthPulse is now operative for the desired Mode, Time and Amplitude.

Note -- If you make a mistake anywhere in the steps defined above, press "Select/Start" button, and then

Step 4.?

restart from

(What is Amplitude? The amplitude defines the gauss density. The Controller, by default,

boots to 70% amplitude for all modes, because we have found this to be the best suited to a

normal user. It can be decreased or increased within a range of 10 to 100 based on the

user's comfort level. You can best do this by experimenting with different levels. If at a given

setting you are not getting the desired results, increase the amplitude; and if there is any

discomfort, then decrease the amplitude).