EarthPulse v.5 Pro Manual de inicio rápido - Página 5
Navegue en línea o descargue pdf Manual de inicio rápido para Productos de cuidado personal EarthPulse v.5 Pro. EarthPulse v.5 Pro 7 páginas.
También para EarthPulse v.5 Pro: Manual (12 páginas)
Imprimir página
C) Testing Magnetic Output:
1) With blue-diode blinking; Lay the fatter rounded side of the ring
across the center of the solid electromagnet core (as shown in photo
below);
2) Raise ring 1/4-1/2 inch (1-2 cm) above core to feel pulsing signal;
3) Move to 3/4 inch or 2-3 cm above core and it is very weak if not
relatively unnoticeable;
4) Use UP/DOWN arrow keys in active mode while holding ring at
1/4 inch (1MM) position to feel amplitude change.
under feather pillow in Alert-Mode (maximum pulse rate). If this com-
pletely safe level of heat makes you uneasy, operate at lower ampli-
tude when magnet is trapped in bedding.
While it may feel hot to touch on the palm side of hand, it should feel
a bit more than warm to the back of hand. At boot amplitude (70%) it
will be slightly more powerful than our last version (v.4.7) with little to
no heat depending upon type of cushions and ambient temperature.
4
Testing magnet output