360 BANDIT Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Maquinaria agrícola 360 BANDIT. 360 BANDIT 2 páginas.

STEP 3 | INSTALL DISK & HOSE GUIDES

Insert 5/8" X 3" bolt through the disk. Insert bushing 7

(large side ﬁ rst) and hose guide assembly 8 (ear tab facing out).

Slide assembly into the lower hole on the bandit 9, aligning

the ear tab with corresponding upper hole 1 and secure

with lock nut.

Tighten with 15/16" socket and wrench.

Using a mallet, install provided dust caps over bolt heads.

Route application hose through hole in top of 360 BANDIT

frame 1.

Repeat for other side.

PAGE 2

360YIELDCENTER.COM

STEP 4 | REINSTALL CLOSING SYSTEM

Use long M12 bolts, washers, and nuts 7 to reattach

closing system casting to the 360 BANDIT unit.

Reinstall insecticide attachment if present.

NOTES:

If the closing wheels were removed but you are not

installing the optional Chain Kit, reinstall the closing

wheels at this time.

If the optional Chain Kit is being installed, do not reinstall

the closing wheels.

If pinning up 360 BANDIT disks while running spiked closing

wheels, mount spiked closing wheels in rear most hole.

INSTALLATION INSTRUCTIONS

STEP 5 | ASSEMBLE PLUMBING

Install included oriﬁ ce plates 1 in the rubber grommets 1.

Assemble pluming components in the arrangement shown

above 1. The supplied push to connect adapter in the 360

BANDIT kit connects to 3/8" push to connect compatible hose.

Secure hoses to row unit with provided zip ties 1.

PLUMBING RECOMMENDATIONS:

To prevent excess fertilizer from dribbling out of the hoses

when product application is shut o , install one Push to

Connect Polypropylene (Inlet x Outlet) 3/8" O.D. check

valve (not included) in the plumbing to each row prior to the

360 BANDIT oriﬁ ces.

A 50 mesh strainer (not included) can be used in the

complete plumbing system between tanks and 360

BANDIT to help prevent debris from blocking oriﬁ ces.

INSTALLATION COMPLETE