EarthWay 2100P Estate Manual de instrucciones de montaje y funcionamiento - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de montaje y funcionamiento para Esparcidor EarthWay 2100P Estate. EarthWay 2100P Estate 6 páginas. Broadcast spreader
También para EarthWay 2100P Estate: Manual de instrucciones de montaje y funcionamiento (8 páginas)
Imprimir página
Bushing
Drawbar
Frame Brace
7. Slide axle bushing over axle and into axle bearing to both sides as shown.
8. Install drive wheel to axle using pin hole nearest to lower handles as shown. Insert 1¾"
Cotter pin through wheel and through axle. Bend with pliers to prevent pin from falling
out.
9. Install coast wheel to axle using outside pin hole. As shown, add the flat washer, and
insert ¾" Cotter pin through axle (
from falling out.
Control
Wire
Small
hole for wire
Shut-Off
Plate
10. Install Control Assembly by inserting bent wire end into the small
hole in the shut-off plate from the bottom of the spreader as shown
above. TIP: The wire will fit into the hole to the first bend, then you need
to lay the Control Wire into the Lower Housing Clip. Close the Lower
Housing Clip with a snap and secure with #10 x ⅝" Screw and snug to a
loose fit - d
t
.
o not
ightEn
TURN SPREADER UPRIGHT ON TO WHEELS.
Gearbox
&
Axle
). Bend with pliers to prevent pin
not thru thE whEEl
Control
Assembly
#30
Rate Handle
¾" Cotter Pin
Flat Washer
Control Wire
Lower Housing Clip
#10 x 5/8"
Screw
Lower Housing Clip
1¾" Cotter Pin
Larger Hole
Larger Hole
PAGE 3