Bushing
7. Slide axle into the lower handle, then the gearbox and into axle bearing on
the other lower handle as shown above. Finally slide the bushings over the
axle as shown above.
8. Install drive wheel onto the axle and align with the cotter pin hole nearest to
lower handles as shown. Insert 2" cotter pin through wheel and through axle.
Bend with pliers to prevent pin from falling out.
9. Install coast wheel onto the axle fully, then using outside cotter pin hole,
insert 1" cotter pin through axle (not thru the wheel). Bend with pliers to
prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEELS.
Shut-Off
Plate
Pivot Rod
with extra bend
10. NOTE: BEFORE INSTALLING GAUGE AND UPPER HANDLES TO HANDLE
SHAFT, UPPER HANDLES FEATURE TWO POSITIONS FOR OPERATOR'S
COMFORT.
Select one of the positions for comfortable use. If operator chooses the upper
position, use handle spacer in hole nearest to handle grips as shown to the right.
Insert 2" bolt through upper handle, then through handle spacer through other
upper handle and secure with locknut.
DO NOT TIGHTEN LOCKNUT YET. TIGHTEN THIS NUT LAST.
Now slide the upper handle assembly over the handle shaft (on the end with
the bolt holes closer to the end). Install gauge & lever using (2) 2" bolts. Be
sure gauge is on left hand side. Tighten locknuts to gauge first. TIGHTEN ALL
HARDWARE NOW.
11. Insert pivot rod into shut-off plate as shown.
Turn to lock in place.
12. Insert other end of pivot rod into pivot and bracket assembly as shown. Turn
to lock in place.
Bushing
Install the axle
as shown above
Rotate
Pivot
Drive wheel side
Coast wheel side
1" Cotter Pin
Upper Handles
Handle
1/4-20
Spacer
Locknuts
POSITIONS
LOWER
UPPER
Handle Shaft
Pivot
Rod
Angle
Attaching
Arm
2" Cotter Pin
1/4-20 x 2"
Hex Head
Bolt
Gauge &
Lever Assembly
Long end
Insert Pivot Rod
into Shut-Off
and rotate to secure
PAGE 3
Imprimir página