EarthWay 2600A-Plus Manual de instrucciones de montaje - Página 2
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Esparcidor EarthWay 2600A-Plus. EarthWay 2600A-Plus 6 páginas. 40 lb broadcast spreader
También para EarthWay 2600A-Plus: Manual de instrucciones de montaje (6 páginas)
Imprimir página
Assembly and Operation Instructions
HELPFUL HINTS
Read the directions before assembly.
If your spreader does not spread evenly, be sure "FRONT" on the GEARBOX points to the front of the spreader. The
impeller must turn clockwise when pushing forward. Reversing the GEARBOX during assembly will cause issues.
Your spreader is calibrated for three miles per hour, which is a brisk walking speed. Slower or faster speeds will
change the spread pattern. Wet fertilizer will also change the spread pattern and flow rate. Do not use powdered
materials as it will damage the gearbox.
Gears are permanently lubricated at the factory. Do NOT open the GEARBOX or dirt may enter.
SPREADER ASSEMBLY INSTRUCTIONS
Remove all components and hardware items
Step 1:
from the box. Place the spreader hopper upside down,
facing away from yourself.
Install the frame using (4) #10 X 1-1/4" Flat
Step 2:
Head Phillips screws. TIGHTEN THESE NOW
Install the gearbox by inserting the pinion
Step 3:
shaft into the hole in the center of hopper bottom. The
arrow on the gearbox must point to FRONT of the
hopper. Follow label instructions on hopper.
Install the lower handles (left and right) onto the frame and secure with (2) ¼-20 x 2¼" bolts through the
Step 4:
hole in the frame braces and through the hole in the frame. Secure with (2)
REMOVE AGITATOR WHEN USING ROCK SALT TO PREVENT GEARBOX DAMAGE.
2600A-PLUS_M52215_July2021
PAGE
¼"-20 nylon lock nuts on the ends.
PAGE 2