Christie 104-006101-XX Manual de instrucciones de instalación - Página 9
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Accesorios para proyectores Christie 104-006101-XX. Christie 104-006101-XX 12 páginas. Stacking frames
Imprimir página
Stacking Frame Installation Instructions
1. If the projector is inverted retract the adjustable feet to prevent the hoisting
hardware from becoming snagged.
When hoisting a non-inverted projector or stack, add two rigging eyebolts in the
front and rear threaded holes on the top of the projector. Ensure the eyebolts are
rated adequately for the load. Secure safety cabling to both eyebolts.
2. Attach a safety cable to each of the two eyebolts
mounted on the bottom of the projector. Refer to
Figure 6.
3. Secure the rigging components to the appropriate
rigging points. Eight sliding points are provided on
the bottom of the projector. To prevent sliding
tighten the nut at each required location.
4. Use at least four rigging points (two opposite
sides) and ensure the straps, clamps or cabling
meet the adequate load capacity for the total
projector(s) weight. Refer to Section 6 of the
manual shipped with the projector for information
on size and weight. DO NOT join the rigging
straps or cables to a common point — keep
separated. Ensure all straps are taut.
013-100342-01 (Rev.1) (08/06)
WARNING
Always use at least two safety cables when hoisting.
9 of 12 pages
Figure 6. Safety Cables