360 Vision Visiondome-VR Manual de instalación y configuración - Página 10
Navegue en línea o descargue pdf Manual de instalación y configuración para Cámara de seguridad 360 Vision Visiondome-VR. 360 Vision Visiondome-VR 16 páginas.
Imprimir página
Visiondome VR Installation Manual Ver 2.7
6 Visiondome VR Protocol/Address setup.
All Visiondome VR cameras are supplied set to 360 Vision protocol, camera twisted pair address 1. When
the Visiondome VR is switched on, an OSD (On Screen Display) is shown on the image from the camera for
approx 20 seconds.
PRO: Protocol being used for telemetry (e.g. 360 Vision Technology Ltd)
CAM: Camera RS485 ID (e.g. Cam 1)
S or L: Short or Long cable run. Use the utility to set whether the coax used to send video is under or over
300m.
Second Line: Shows the Visiondome VR Software Version loaded into the camera.
To change the above settings in the camera, 360 Predator utility software, a USB/RS485 cable (PRED-
USB-485) and a laptop are required.
The Predator utility and PRED-USB-485 cable drivers can be found on the CD (shipped with the camera) or on
the 360 Vision Technology web site (www.360visiontechnology.com/downloads).
Install the software (Predator-issued-120521-1-installer.exe) on the laptop being used. Connect the RS485 end
of the cable fitted with a 3 way connector to the Visiondome VR RS485. Run the utility on the laptop and then
connect the USB end of the cable into the laptop. The utility will then look for new comms ports and then will
look for the camera across all baud rates used.
Settings that can be altered from this software are:
•
Protocol: 360 (Coax/RS485), Pelco P 2400/4800/9600, Pelco
D 2400/4800/9600, Pelco Coaxitron (Extended version), VCL
(Coax/RS485), Ultrak (RS485), Forward Vision (RS485)*,
BBV/DENNARD C (FSK Coax), MARK MERCER (FSK Coax),
Molynx (Coax/RS485)*/**
•
Coax Cable length: Longer than 300m or shorter than 300m.
•
RS485 Address: Used on RS485 systems only.
*Molynx & Forward Vision are not available in the Visiondome VR
camera.
** Choose Molynx to set the camera to Mark Mercer (RS485)
(units supplied Dec 2017)
PRO:360VTL CAM:0001
Visiondome VR Software Version
© 360 Vision Technology Ltd.
S
Page 10