Miele PWM 920 DD Plan de instalaciones - Página 4

Navegue en línea o descargue pdf Plan de instalaciones para Lavadora Miele PWM 920 DD. Miele PWM 920 DD 34 páginas. Commercial washing machine

en - Installation and planning notes

Installation on

concrete base

The washing machine must be installed by Miele Service or by

properly trained staff of an authorized dealer.



This washing machine must be installed in accordance with all rel-

evant regulations and standards. Local energy supplier regulations

must also be observed.



This washing machine must only be operated in a room that has

sufficient ventilation and which is frost-free.

The washing machine should not be installed or operated in any

area where there is a risk of explosion.

This washing machine is intended only for use in a commercial envi-

ronment and must only be operated indoors.

- Ambient temperature: 32-105°F (0-40°C)

- Relative humidity: non-condensing

- Maximum height above sea level of location site: 6500 ft (2000 m)

Depending on the nature of the installation site, sound emissions and

vibration may occur.

Tip: Have the installation site inspected and seek the advice of a spe-

cialist in instances where increased noise may cause a nuisance.

The washing machine must be set up on a level and firm surface with

the minimum stated load bearing capacity (see "Technical data").

The floor load created by the washing machine is concentrated and

transferred to the installation footprint via the machine feet.

Tip: A concrete floor is the most suitable installation surface for this

appliance. It is far less prone to vibration during the spin cycle than

wooden floorboards or a carpeted surface.

The washing machine requires a gap of at least 2" (50 mm) at each

side to allow for movement during operation. To ensure suitable ac-

cess for further maintenance and service work, please ensure a mini-

mum distance of 16" (400 mm) is maintained between the back of the

machine and the wall.

Machines with an integrated sampling valve must have a gap of at

least 8" (200 mm) on the left hand side.

The washing machine can be installed on a concrete base if desired.

The concrete materials and the durability of the concrete base must

be assessed in accordance with the floor load bearing capacity

given in "Technical data".