Miele W 6071 Instrucciones de uso e instalación - Página 31
Navegue en línea o descargue pdf Instrucciones de uso e instalación para Lavadora Miele W 6071. Miele W 6071 44 páginas.
También para Miele W 6071: Manual de instrucciones (40 páginas), Manual de instrucciones (38 páginas)

Fault messages
,Repairs should only be carried out by a
qualified and trained person in accord-
ance with local and national safety
regulations. Unauthorized repairs could
cause an injury or machine damage.
Faults that occur before or after the start of a
program flash in the display.
PROGRAMME 11
PROGRAMME STOP
THROUGH POWER CUT
Press "Start" to continue the program.
^ Once power is restored, press X "Start".
This fault message can also indicate: The
overload cut-out of the drive motors has over
heated. Allow the motor to cool down.
PROGRAMME 11
PROGRAMME STOP
WATER INLET FAULT
Open water stopcock and press Start button.
^ Open the water valve (stopcock) and
press X "Start".
PROGRAMME 11
PROGRAMME STOP
DRAIN FAULT
Check drain system and press Start button.
^ Check and clean the drain system and
press X "Start".
PROGRAMME 11
PROGRAMME STOP
HEATING SYSTEM FAULT
Short circuit on heat sensor 1.
^ Contact Technical Service.
PROGRAMME 11
PROGRAMME STOP
HEATING SYSTEM FAULT
Cut-out on heat sensor 1.
^ Contact Technical Service.
COTTONS
COTTONS
COTTONS
COTTONS
COTTONS
Frequently asked questions
PROGRAMME 11
PROGRAMME STOP
HEATING SYSTEM FAULT
^ Contact Technical Service.
PROGRAMME 11
PROGRAMME STOP
DRIVE SYSTEM FAULT
Multiplug drive variants failure.
^ Contact Technical Service.
PROGRAMME 11
90 °C
Main wash
Rinse 1
DRIVE SYSTEM FAULT
^ Contact Technical Service. if there is no
drum movement after this message.
PROGRAMME 11
PROGRAMME STOP
IMBALANCE SWITCH
Press the On-Off switch.
^ Press Z "Power off" and Y "Power on".
PROGRAMME 11
PROGRAMME STOP
PRESSURE MONITOR FAULT
^ Contact Technical Service.
PROGRAMME 11
PROGRAMME STOP
DISPENSING SYSTEM FAULT
Dispensing container 1 empty
^ Change the dispensing container.
COTTONS
COTTONS
COTTONS
20 °C
COTTONS
COTTONS
COTTONS
31