Miele WS 5141 Manual de instrucciones - Página 23

Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Miele WS 5141. Miele WS 5141 32 páginas. Washer-extractor

Imprimir página

Fault messages

Repairs should only be performed by a

qualified technician in accordance with

applicable codes and standards. Repairs

and other work by unqualified persons

could be dangerous and the manufacturer

will not be held responsible.

Faults that occur before or after the start of a

program are shown in a flashing display.

PROGRAMME

PROGRAMME STOP

THROUGH POWER CUT

Please press the Start button.

^ When power is restored press X "Start".

This fault message can also indicate that the

winding protection of the drive motor has

overheated.

^ Allow the motor to cool down.

PROGRAMME

PROGRAMME STOP

WATER INLET FAULT

Open water stopcock and press Start button.

^ Open up the water stopcock (valve) and

press X "Start".

PROGRAMME

PROGRAMME STOP

DRAIN FAULT

Clean drain system and press Start button.

^ Check the drainage system on site and

press X "Start". A defective drain valve

should only be repaired by an authorized

service technician.

PROGRAMME

PROGRAMME STOP

HEATING SYSTEM FAULT

Short circuit on heater sensor 1.

^ Call the Miele Technical Service Depart-

ment.

COTTONS

Problem solving guide

PROGRAMME

PROGRAMME STOP

HEATING SYSTEM FAULT

Cut-out of heating sensor 1.

^ Call the Miele Technical Service Depart-

ment.

PROGRAMME

PROGRAMME STOP

HEATING SYSTEM FAULT

^ Call the Miele Technical Service Depart-

ment.

PROGRAMME

PROGRAMME STOP

DRIVE SYSTEM FAULT

Multiplug drive variants lacking.

^ Call the Miele Technical Service Depart-

ment.

PROGRAMME 1

95 °C

Main wash

Rinses

DRIVE SYSTEM FAULT

^ Call the Miele Technical Service Depart-

ment if there is no drum movement after

this message.

PROGRAMME 1

PROGRAMME STOP

PEAK LOAD CUT OUT ACTIVE

At the end of the peak load cut out function

the program continues automatically.

PROGRAMME 1

PROGRAMME STOP

IMBALANCE SWITCH

Press the On-Off switch.

^ Press Z "Power off" and Y "Power on".

COTTONS

20 °C

^^^^^^^^^

COTTONS