Miele WS 5320 Manual de instrucciones - Página 24

Navegue en línea o descargue pdf Manual de instrucciones para Lavadora Miele WS 5320. Miele WS 5320 36 páginas. Washer-extractor

Imprimir página

Liquid dispensing

Setting the amount dispensed by the

pump

The amount to be dispensed is measured in

liters in the service program.

The dispensing time fixed is then set in oper-

ating mode C "Programming".

^ Insert the suction pipe into a measuring

container with sufficient proofing agent

and maintain the fill level.

SERVICE-OPERATION

>SERVICE PROGS<

After selection press Start button.

^ After selection press the X "Start" button.

Select SERVICE PROGRAMME 2 and

press the X "Start" button.

SERVICE-OPERATION

SERVICE PROGRAMME

Dispenser valve >D1<

After selection press Start button.

^ With the 4 "Plus" button select D6.

^ With the cursor button move to the input

field for dispensing time and with the 4

"Plus" button set a dispensing time.

SERVICE-OPERATION

SERVICE PROGRAMME

Dispenser valve >D6<

After selection press Start button.

^ Press the X "Start" button and the pump

will draw a certain amount from the mea-

suring container.

^ Repeat this process until the desired dis-

pensing amount is set.

Maintain the dispensing time because this

time must be carried over into the program

to be run.

^ Cancel with the 7 "End" button and turn

off the machine.

^ Turn on the machine and select Separate

Drain, to flush the proofing agent deter-

gent out of the machine.

MACHINE DATA

SERVICE PROGS

Disp. time 0 Secs.

SERVICE PROGS

Disp. time 35 Secs.

^ Set the access key to position C "Pro-

gramming" and select menu point ALTER.

^ Select the number of the Proofing program

with the 4 "Plus" or 3 "Minus" button.

Press X "Start".

^ If the U "Starch" button is pressed, the

LED lights up, and then the 2 "Cursor" (or

1) is pressed, the cycle is skipped

through to the end (or back again). In the

area programming and at each end of a

block the skipping is stopped and the dis-

play calls for "saving".

If the X "Start" button is pressed this

jumps into the next block.

PROGRAMMING

PROGRAMME

Dispensing 1

>D 1/ 0 Secs, D 1/ 0 Secs <

Disp. delay 1

>no<

^ Once the dispensing point has been

found, set D6 with the 4 "Plus" button and

with the 2 "Cursor" move to the input field

for dispensing time, and with the 4 "Plus"

button set the fixed dispensing time.

PROGRAMMING

PROGRAMME 18

WASH/PROOF & SPRAY

Dispensing 1

>D 6/ 60 Secs, D 1/ 0 Secs<

Disp. delay 1 >no<

^ Skip the program through to the end and

press X "Start" to save.

^ To start the program turn the access key to

position B "Operation".

ALTER

WASH/PROOF & SPRAY

ALTER