Miele KMR1356 G Instrucciones de instalación - Página 10
Navegue en línea o descargue pdf Instrucciones de instalación para Campana de ventilación Miele KMR1356 G. Miele KMR1356 G 21 páginas.
Imprimir página
Electrical connection
ATTENTION:
During installation, maintenance and
repair work, the rangetop must be
disconnected from the electricity
supply. It is only completely isolated
from the electricity supply if the plug
fuses have been fully unscrewed
(where applicable), the main circuit
breaker has been tripped or the
power cable has been unplugged
from the wall outlet.
Do not cut off the plug on the power
cord. If the plug does not fit in the
outlet, have an electrician install an
appropriate outlet.
The socket must be easily accessi‐
ble after the rangetop has been in‐
stalled.
Installation, repair and maintenance
work should only be performed by a
Miele authorized service technician.
Work by unqualified persons can
cause considerable danger to users.
Miele cannot be held liable for any
damage arising as a result of such
work.
To avoid damaging the rangetop,
make sure that the information (volt‐
age and frequency) on the data plate
correspond to the building's power
supply before connecting the appli‐
ance.
When in doubt, consult a qualified
electrician.
The power cable plug must be in‐
serted into a suitable outlet that has
been installed and grounded in com‐
pliance with all applicable local regu‐
lations.
46
WARNING: THIS APPLIANCE MUST
BE GROUNDED
Installer: Please pass these instruc‐
tions on to the customer.
Electrical connection
The rangetop is equipped with an ap‐
prox. 4 ft. long power cord with a plug
for connection to the electrical supply
with:
– 120 V, 15 A, 60 Hz
SAVE THESE INSTRUCTIONS FOR
THE ELECTRICAL INSPECTOR'S
USE.
This appliance must be grounded in
compliance with all applicable local
and national regulations.
Installation, repair and maintenance
work should only be performed by a
Miele authorized service technician
in compliance with local regulations
and the ANSI National Electrical
Code / NFPA 70 in the United States
or the Canadian Electrical Code, Part
I in Canada (CSA standard C22.1).