Miele HS08 Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Aspiradora Miele HS08. Miele HS08 23 páginas.

Miele HS08 Manual de instrucciones
en
The illustrations referred to in the text
are shown on the fold-out pages at
the end of these operating
instructions.

Preparing for use

Assembling the vacuum cleaner (dia.
1)
^ Raise the vacuum cleaner into the
vertical position.
^ Insert the handle into the vacuum
cleaner until it clicks into position.
To activate the exhaust filter change
indicator
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
2):
a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
If your vacuum cleaner is fitted with
filter b or c, you need to activate the
exhaust filter change indicator.
^ Open the lid of the exhaust filter
compartment and pull the exhaust
filter a little way out of the holder
(dia. 3).
^ Remove the label, then put the
exhaust filter back in again (dia. 4).
^ Press the exhaust filter change
indicator ~ (dia. 5).
36
^ After approx. 10 - 15 seconds a thin
red stripe will appear in the left hand
side of the display (dia. 6).
^ Close the exhaust filter compartment
lid.
Exhaust filter change indicator
The exhaust filter change indicator
shows the remaining functional life of
the exhaust filter. After approx. 50
operating hours, or approx. one year of
average use, the display will be
completely filled with red (dia. 7).

Use

Unwind the mains cable (dia. 8)
The lower cable hook can be turned in
either direction.
^ Turn it upwards to release the cable.
Winding up the mains cable (dia. 9)
When the vacuum cleaner is not in use,
the cable can be wound around the two
cable hooks.
Secure the mains cable by clamping
the plug to the cable (see detail).
Mains cable whilst vacuuming (dia.
10)
^ Whilst vacuuming, the mains cable
can be fed through the guide at the
side of the upper cable hook (see
detail).
This way the mains cable will not get in
the way during vacuuming. This also
protects the cable from becoming
kinked.