Miele K 12820 SD edt Manual de funcionamiento e instalación - Página 10

Navegue en línea o descargue pdf Manual de funcionamiento e instalación para Frigorífico Miele K 12820 SD edt. Miele K 12820 SD edt 48 páginas. Refrigerator with dynamiccooling
También para Miele K 12820 SD edt: Manual de funcionamiento e instalación (40 páginas), Instrucciones de uso e instalación (44 páginas), Instrucciones de uso e instalación (44 páginas), Instrucciones de uso e instalación (48 páginas)

Miele K 12820 SD edt Manual de funcionamiento e instalación
Warning and Safety instructions
~
The more coolant there is in an appliance, the larger the room it
should be installed in. In the event of a leakage, if the appliance is in
a small room, there is the danger of combustible gases building up.
For every 8 g of coolant at least 1 m
amount of coolant in the appliance is stated on the data plate inside
the appliance.
~
To avoid the risk of damage to the appliance, make sure that the
connection data (fuse rating, frequency and voltage) on the data
plate corresponds to the household supply before connecting the
appliance to the mains supply. Check that this is the case before
connecting the appliance. Consult a qualified electrician if in any
doubt.
~
The electrical safety of this appliance can only be guaranteed
when it is correctly earthed. It is most important that this basic safety
requirement is observed and regularly tested and where there is any
doubt, the household wiring system should be inspected by a
qualified electrician.
~
If the electrical connection cable is faulty it must only be replaced
by a Miele approved service technician to protect the user from
danger.
~
Do not connect the appliance to the mains electricity supply by a
multi-socket adaptor or extension lead . These are a fire hazard and
do not guarantee the required safety of the appliance.
~
Do not use in a damp environment (e.g. garage or utility room).
Moisture could reach live components or the electrical connection
and cause a short circuit.
~
This appliance must not be used in a non-stationary location (e.g.
on a ship).
10
3
of room space is required. The