Miele CS 1112 E Instrucciones de uso e instalación - Página 24
Navegue en línea o descargue pdf Instrucciones de uso e instalación para Placa de cocción Miele CS 1112 E. Miele CS 1112 E 40 páginas. Ceramic cooktop
También para Miele CS 1112 E: Manual de funcionamiento e instalación (40 páginas), Manual de instrucciones de instalación (22 páginas)
Imprimir página
IMPORTANT INSTALLATION SAFETY INSTRUCTIONS
Note to the installer:
Please leave this instruction book
with the consumer for the local
electrical inspector's use.
The minimum distances given in
these Installation Instructions must
be observed in order to ensure safe
operation. Failure to do so increases
the risk of fire.
The cabinetry and venting hood
should be installed first to prevent
damage to the combiset.
~
The countertop must be bonded
with heat resistant (212°F/100°C)
adhesive to prevent distortion or
dissolving.
Any back splashes should be
heat-resistant as well.
~
The combiset must not be installed
over a dishwasher, washer, dryer,
refrigerator or freezer. Heat radiated by
the combiset may damage them.
~
To eliminate the risk of burns or fire
by reaching over heated surfaces
cabinet storage space above the
appliance should be avoided. If cabinet
storage is necessary, the risk can be
reduced by installing a venting hood to
project horizontally a minimum of 5"
(127 mm) beyond the bottom of the
cabinets.
24
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
Do not install this appliance above
an oven unless the countertop is at
9
least 1
/
" (40 mm) thick.
16
~
You must ensure the power cable
for the appliance will not come into
contact with the floor panel after
installation, nor be subject to any
mechanical strain.
~
The appliance must not be
permanently sealed into the countertop
when installed. The sealing strip under
the edge of the appliance provides a
sufficient seal for the countertop. See
"Sealing".
Keep this instruction book in a safe
place for reference and pass it on to
any future user.