ALLNIC AUDIO T-2000 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Amplificador ALLNIC AUDIO T-2000. ALLNIC AUDIO T-2000 17 páginas. 30th anniversary stereo integrated amplifier
También para ALLNIC AUDIO T-2000: Manual del usuario (11 páginas)

Imprimir página

You can use the T-2000 30th Anniversary with a separate preamplifier by connecting the outputs of the

preamplifier to one pair of the T-2000 30th Anniversary 's inputs.

do this. If you have both volume controls above zero on turn on, especially with signal, you could

damage your speakers because of the extreme volume level from the combined gain of both the

preamplifier and the T-2000 30th Anniversary.

have the volume on BOTH units set to zero. Then use the volume control on both the pre-amp and the T-

2000 30th Anniversary to set the volume control on the T-2000 30th Anniversary so that you can use the

preamplifier volume control as the main volume control – OR vice versa, as you prefer.

SPEAKER TERMINALS

The T-2000 30th Anniversary is equipped with two pairs of high-quality speaker terminals. These terminals

are located at the left of the back of the chassis (the right, facing the front of the chassis). Facing the front

of the chassis, the right channel pair is on the outside right and the left channel pair is to their left, on the

other side of the impedance toggle. The terminals accept bare wire (not recommended) and spade and

banana type connectors. Positive terminals are on top; negative below. Please refer to Figure 5.

POWER CONNECTION

Connect the input interconnects and the speaker cables before you insert the power cable into the

receptacle at the centre of the chassis rear. The T-2000 30th Anniversary uses a standard three prong

male IEC connection for AC input. You need to use a power cord with a female three prong IEC connector

at one end. Please refer to Figure 5.

The T-2000 30th Anniversary you have purchased is set internally for AC 110 volt – 60 Hz or 230 volt -

50/60 Hz operation.* It is possible to change this to another AC setting without return of the unit to the

factory for re-wiring. Please contact your Allnic dealer for assistance.

*120 or 240 volt is also available on request.

INITIAL POWER-ON

Once you have your T-2000 30th Anniversary in place and all connections have been made to your

turntable and preamplifier, you are ready to turn on the power for your T-2000 30th Anniversary; before

you power it up, though, be sure you have:

•

removed ALL the cushion materials (cardboard around tubes) from inside the tube chimneys.

•

checked that power tubes are snug in their sockets. Use caution so as not to break the centre pin of

the KT170's octal base.

for such an outcome.

• ensured the interconnects are firmly attached.

• Turned on your source(s) and zeroed their volume controls or muted them.

•

turned the preamplifier's and T-2000 30th Anniversary's volume controls down to zero (if you use

that

combination).

• securely and correctly fastened the speaker cables and ensured that they are also connected properly

to the speakers.

On initial turn on with a separate pre-amp, you should

Allnic Audio, its dealers and authorized representatives are not responsible

HOWEVER, please use caution when you