ALLNIC AUDIO D-3000 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Media Converter ALLNIC AUDIO D-3000. ALLNIC AUDIO D-3000 11 páginas. Digital to analog converter
Imprimir páginaC. INPUTS
The D-3000 DAC has the following inputs:
One optical ("Toslink") digital
•
One USB
•
One AES/EBU digital
•
Two (2) coaxial digital
•
To select the input you want to play, rotate the knob on the right of the D-3000's front panel clockwise
and counter-clockwise, or use the appropriate part of the remote control (See the section "The
Remote Control" below).
The D-3000 utilizes a non-PLL digital receiver for lower noise. To avoid introduction of noise and/or
connectivity issues, the user should be sure to use high quality digital sources and cables that meet
applicable standards for the selected input (e.g., AES/EBU, S/PDIF).
D. OUTPUTS
The D-3000 is equipped with one pair of unbalanced or "single-ended" (RCA) outputs and one pair of
true balanced (XLR) output connections. Each output pair is oriented horizontally. WHEN FACING THE
REAR OF THE DAC , the:
XLR and RCA output connections are to the left of the IEC power connection;
•
switch to change between balanced and unbalanced connection is between the AC power IEC
•
connection and the XLR (balanced) output connector pair;
RCA (unbalanced) connectors are to the left of the XLR (balanced pair); and
•
left channel output connector for each output pair is to the right of the right channel connector.
•
The left channel output connectors are labeled "L", and the right channel output connectors are
labeled "R" .
As noted above, the switch to change between balanced and unbalanced connection is between the
AC power IEC connection and the XLR (balanced) output connector pair. The switch is labeled to
indicate that the upper position is for the balanced (XLR) output connectors, with the lower position
being for the unbalanced (RCA) output connectors. You may have both balanced and unbalanced
outputs connected at the same time without introducing hum PROVIDED you have the output switch
set to unbalanced output.
E. EXTERNAL CLOCK CONNECTION
The D-3000 is equipped with BNC type in and out reference word clock connectors for use with an
external clock.