Allo RemoteControl Prastel SLIM2E Instrucciones

Navegue en línea o descargue pdf Instrucciones para Mando a distancia Allo RemoteControl Prastel SLIM2E. Allo RemoteControl Prastel SLIM2E 2 páginas.

ENTERING NEW TRANSMITTERS INTO THE MEMORY OF THE RECEIVER:

1. Press the programming pushbutton in the receiver. The LED lights up.

2. Press any of the transmitter's keys: the code is now entered in the

memory. While loading is in progress, the LED flashes then stops

flashing and becomes fixed. A new code can now be entered.

3. At the end, press again the pushbutton in the receiver to exit from

programming mode. The LED will go off. In any case, the system will

automatically exit from programming mode after 10 seconds having

elapsed since last loading.

REMOTELY ENTERING NEW TRANSMITTERS INTO THE MEMORY OF THE

RECEIVER:

1. Approach an already programmed transmitter to the receiver (at a distance of 1-2 m).

2. Press buttons 1 and 2 of the transmitter at the same time and release them: the LED turns on

and after 2 seconds turns off.

Visit our website: www.Alloremotecontrol.com

3. When the LED turns on, press again buttons 1 and 2 of the transmitter at the same time, and

hold them until the LED starts flashing.

4. At the end of flashing, the TX sends a transmission which activates the learning function of the

receiver.

5. The receiver waits 10 seconds for transmissions from new transmitters. Press one of the buttons

of the transmitter to be learned. The receiver stores the new transmitter into its memory.

6. During the learning procedure, the 10 seconds learning timeout is restored at any new

transmitter learned.

Visit our website : www.alloremotecontrol.com

Prastel SLIM2E/ SLIM4E

Visit our website: www.Alloremotecontrol.com

INSTRUCTIONS