Dialighting IS200-MH Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Luminaria Dialighting IS200-MH. Dialighting IS200-MH 6 páginas.

Imprimir página

-This light should be keep away from strong shaking during any transportation or movement.

-Don't pull up the light by only the head, or it might cause damages to the mechanical parts.

-Don't expose the fixture in overheat, moisture or environment with too much dust when installing

it. And don't lay any power cables on the floor. Or it might cause electronic shock to the people.

-Make sure the installation place is in good safety condition before installing the fixture.

-Make sure to put the safety chain and check whether the screws are screwed properly when

installing the fixture.

-Make sure the lens are in good condition. It's recommended to replace the units if there are any

damages or severe scratch.

-Make sure the fixture is operated by qualified personnel who knows the fixture before using.

-Keep the original packages if any second shipment is needed.

-Don't try to change the fixtures without any instruction by the manufacturer or the appointed

repairing agencies.

-It is not in warranty range if there are any malfunctions from not following the user manual to

operate or any illegal operation, like shock short circuit, electronic shock, lamp broke, etc.

4. 4. 4. 4. Mounting

Mounting

Mounting and

and

and Installation

Installation

Cautions: For added protection mount the fixtures in areas outside walking paths, seating areas,

Cautions:

or in areas were the fixture might be reached by

unauthorized personnel.

Before mounting the fixture to any surface, make sure that the installation area can hold a

minimum point load of 10 times the device's weight.

Fixture installation must always be secured with a secondary safety attachment, such as an

appropriate safety cable.

Never stand directly below the device when mounting, removing, or servicing the fixture from a

ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept at least

0.5m (1.5 ft) away from any flammable materials (decoration etc.).

Always use and install the supplied safety cable as a safety measure to prevent accidental

damage and/or injury in the event the clamp fails.

Mounting

Mounting points:

points: Overhead mounting requires extensive experience, including amongst others

points:

calculating working load limits, a fine knowledge of the installation material being used, and

160-179

180-199

200-219

220-255

0-127

Gobo 1

128-189

Rot.

190-193

194-255

0-009

010-019

020-029

030-039

040-049

050-059

060-069

070-079

080-089

090-099

Gobo 2

100-111

112-123

124-135

136-147

148-159

160-171

172-183

184-195

196-207

208-255

0-031

032-063

Gobo 5 shake slow to fast

Gobo 6 shake slow to fast

Gobo 7 shake slow to fast

Rot. gobo wheel cont. rotation slow to fast

Gobo indexing

Forwards gobo rotation from fast to slow

Gobo rotation stop

Backwards gobo rotation from slow to fast

Open/hole

Gobo 1

Gobo 2

Gobo 3

Gobo 4

Gobo 5

Gobo 6

Gobo 7

Gobo 8

Gobo 9

Gobo 1 shake slow to fast

Gobo 2 shake slow to fast

Gobo 3 shake slow to fast

Gobo 4 shake slow to fast

Gobo 5 shake slow to fast

Gobo 6 shake slow to fast

Gobo 7 shake slow to fast

Gobo 8 shake slow to fast

Gobo 9 shake slow to fast

Gobo wheel rotation from slow to fast

Shutter closed

shutter open