Dialighting LED-PAR64-3W-RGB Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Equipo para DJ Dialighting LED-PAR64-3W-RGB. Dialighting LED-PAR64-3W-RGB 6 páginas. Led par

Imprimir página

DMX

Addrss Setting

4 CH

7 CH

Master Mode

Slave Mode 1

Slave Mode 2.

Sound-Control

Color-Control

Color Fade

OFF

Displaying disp, it is positive

Displaying psid, it is reverse

Perform Mode.

Examine Mode

Master Mode

Special Note: Line Termination:

When longer runs of cable are used, you may need to use a terminator

on the last unit to avoid erratic behavior. A terminator is a 90-120 ohm

1/4 watt resistor which is connected between pins 2 and 3 of a male

XLR connector (DATA + and DATA -). This unit is inserted in the female

XLR connector of the last unit in your daisy chain to terminate the line.

Using a cable terminator will decrease the possibilities of erratic

behavior.

Terminationreducessignalerrors and

Figure4

avoids signaltransmission problemsand

interference.lt is always advisadleto

connect a DMX

terminal,(Resistance120Ohm

1/4W)between PIN2(DMX-)and

PIN3(DMX+)of the last fixture

5-Pin XLR DMX Connectors:

Some manufactures use 5-pin XLR connectors for DATA transmission in

place of 3-pin. 5-pin XLR fixtures may be implemented in a 3-pin XLR DMX

line. When inserting standard 5-pin XLR connectors in to a 3-pin line a

cable adaptor must be used, these adaptors are readily available at most

electric stores. The chart below details a proper cable conversion.

3-Pin XLR to 5-Pin XLR Conversion

Conductor

3-Pin XLR Female(Out

Ground/Shield

Pin 1

data COmpliment(-signal)

Pin 2

Data True(+signal)

Pin 3

Not Used

)

5-Pin XLR Male(ln)

Pin 1

Pin 2

Pin3

Do Not Use