Alloy GCR2000xx Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Media Converter Alloy GCR2000xx. Alloy GCR2000xx 10 páginas. 10/100/1000mbps to 1000base-xx fibre optic media converter
Imprimir página4. Installation
Note: When used in the DCR12xx Chassis the Media Converter is hot-swappable.
Wear a grounding device for electrostatic discharge.
As a standalone unit:
⇒ Verify the AC-DC adapter conforms to your country AC power requirement and insert
the power plug
⇒ If powering via USB cable plug USB cable into suitable USB device such as a Computer
with available USB ports.
For use in the DCR12xx:
⇒ Slide the media converter into one of the spare slots on the DCR12xx chassis.
Fibre Port
Attach the fibre cable. The Tx, Rx fibre cable must be paired at both ends
Attach TP Cat. 5 or above cable to TP port
10/100Mbps
Auto-Negotiation
Auto-MDIX
Flow Control for Full Duplex
TP Port
Backpressure for Half Duplex
1000Base-T
Auto-Negotiation
Auto-MDIX
Flow Control for Full Duplex Only
5. WDM Single Fibre Models
The GCR2000 Series have models available that support Wave Length Division Multiplexing.
This allows the media converter to use a single fibre optic strand to transmit and receive
data over the single fibre. This is achieved by transmitting and receiving data on different
wavelengths.
Single Fibre Model
1310nm Single-Mode 20Km
1550nm Single-Mode 20Km
Note:
The 1310nm and 1550nm models must be installed in pairs. i.e. install 1310nm model at one
end of the fibre run and 1550nm model at the other end.
Alloy Computer Products Pty Ltd Copyright ©2010
GCR2000xx User Manual
TX, RX Wavelength
TX (Transmit)
1310nm
RX (Receive)
1550nm
TX (Transmit)
1550nm
RX (Receive)
1310nm