Allpax SM4 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Cortador Allpax SM4. Allpax SM4 12 páginas. Allen rotary-style gasket cutter

ASSEMBLY

Carefully unpack the unit. For shipping, the scale bar is stored in an

inverted position. Loosen the scale bar T-screw and remove the scale

bar. Re-insert the scale bar into its proper position and tighten T-screw.

The Model SM4 comes pre-adjusted at the factory.

(Figure 1) Model SM4 is a heavy-duty unit and is typically bolted

to the flat surface of a workbench using the four 3/8" diameter holes

on the mounting base.

(Figure 2) Proper hand crank rotation as viewed from side.

NOTE: In the instructions that follow, turning the hand

crank in the direction of the arrow above is considered

clockwise.

OPERATING THE UNIT

Model SM4 is designed to cut both metallic and non-metallic gasket

materials. It ships with a factory installed top cutting disc designed

for cutting metal gasket materials. A spare top cutting disc designed

for cutting non-metal gasket materials is also included and can be

installed in the field.

NOTE: The pre-installed bottom cutter will cut both

metal and non-metal materials.

Select the sheet gasket material to be cut. Measure the material and

cut into a rough square making sure that the shortest side measures

larger than the outside diameter (OD) of the gasket to be cut. Trim the

corners if necessary.

For metallic gasket materials, punch, or drill, 3/8" guide hole in the

approximate center of the trimmed gasket material. For non-metallic

gasket materials, punch 11/32" guide hole (#13 punch).

NOTE: Punching the exact diameter guide hole ensures

that the gasket material stays centered and that the cutter

tracks properly.

(Figure 3) Loosen the scale bar T-screw and slide the scale bar to

the desired OD setting. Hand tighten the T-screw.

NOTE: Markings on the scale bar designate radius, not

diameter.

(Figure 4) Disengage the top cutting disc by rotating the cutting

disc lever counter-clockwise.